Troubleshooting Remote Destination - Call does not ring mobile phone
CUCM 6. Remote Destination Profile has been configured and is associated with the primary DN of the deskphone. I set the "No answer ring duration" on the primary line to 20 and then set the "Answer too late" on the on the remote destination to 25000. I did this to try to see where the phone call was going (this is a user for my client and I work remotely so I dont have physical access to either device). I have also set the "Delay before ringing" value to 0 - so the mobile device should ring virtually simultaneously with the desk phone.
When I dial the DN of the deskphone, I get 4 rings and then it goes to UCX (I can tell because I get the opening greeting "Sorry, <user> is not available".
I am able to dial the mobile device directly, and after about 8 rings it goes to voicemail.
There are other users configured for Remote Destinations and they are working. I have done a side by side comparison for the last hour and am not able to see why the mobile device is not ringing.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.