Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Trunk between CUCM 7 and 4.3

Dears,

I'm configuring a NonGwtekeeper Controlled trunk between CUCM 7 and CUCM 4.3

Calls from 4.3 to 7 are successful, but the reverse way is not working,

Kindly advice about that.

9 REPLIES
Green

Re: Trunk between CUCM 7 and 4.3

Check Device Pool of trunks and remote IP address. (ie)

cluster A (cucm 4.3) 3 servers

cluster B (cucm 7.0.1) 2 servers

when u configure in cluster A, the ICT,

2 things:

a)ICT Device Pool should have the 3 servers in its CCM group.

b) Remote server should contain 2 IP addresses of remote servers

when u configure in cluster B, the ICT,

2 things:

a)ICT Device Pool should have the 2 servers in its CCM group.

b) Remote server should contain 3 IP addresses of remote servers

HTH

New Member

Re: Trunk between CUCM 7 and 4.3

actually i didn't understand well what do u mean.

i only hve one CUCM 7.0.1 and one CUCM 4.3

anyway,

thanks for ur reply.

Green

Re: Trunk between CUCM 7 and 4.3

check Calling search spaces, locations and regions then.

New Member

Re: Trunk between CUCM 7 and 4.3

i didn't configure any Calling Search Spaces, those are fresh servers, i'm doing test in our lab.

i did configure locations and regions.

first i need to know if this type of trunk should work successfully, and has been tested.

New Member

Re: Trunk between CUCM 7 and 4.3

actually i didn't understand well what do u mean.

i only hve one CUCM 7.0.1 and one CUCM 4.3

anyway,

thanks for ur reply.

Green

Re: Trunk between CUCM 7 and 4.3

Then it does not apply, check Incoming CSS for ICT Trunk.

R u using MTP required?

New Member

Re: Trunk between CUCM 7 and 4.3

sorry for the inconvenience

the 4.3 server has configurations, but the CUCM 7 is a new one..

u meant incoming CSS on 4.3

New Member

Re: Trunk between CUCM 7 and 4.3

no mtp required

New Member

Re: Trunk between CUCM 7 and 4.3

thanks man,

i just needed to check the CSS.

153
Views
4
Helpful
9
Replies