Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

trunk-group command under controller T1 in which IOS is available

Hi All,

Quick question, I would like to know if the trunk-group under the controller t1 is available in the 15.T train currently I have the following IOS

152-2T

153-1T

and neither IOS have the command. But in the 15.M train (151-4M) I have it.

Basically what I want to accomplish is to reserve 2 B channels for Emergency calls, something like this:

controller T1 0/0/0

pri-group timeslots 1-24

trunk-group Emergency timeslots 1

trunk-group Standard timeslots 2-24

Thanks in advance

Regards

Carlito

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

trunk-group command under controller T1 in which IOS is availabl

It should be available, did you define the trunk group first as "trunk group XXX" in global config?

Chris

5 REPLIES
New Member

trunk-group command under controller T1 in which IOS is availabl

Hi,

The IOS 15T is universal and have the comand trunk-group in T1 interfaces.

Do you only need a license for UC in IOS and enable this UC features.

Regards.

J Rosa.

New Member

trunk-group command under controller T1 in which IOS is availabl

Hi Fernando,

Thanks for the answer. I already checked the lic, I have the UCK9 lic permanent.

More  over I have another router with 15.2.(4)M3 and it doesn't have the  trunk-group. the only similar option is the tdm-group but this command  is for CAS and I need it for PRI.

I  haven't checked a GW with a 15.1(x)T version to see if it is there. So  far I have seen the command only in the 15.1(x)M version.

Regards

Hall of Fame Super Silver

trunk-group command under controller T1 in which IOS is availabl

It should be available, did you define the trunk group first as "trunk group XXX" in global config?

Chris

New Member

trunk-group command under controller T1 in which IOS is availabl

Hi,

The Chris is right, if you did not declare the trunk group before, he'll be available at the interface T1 Pri.

Ex:

trunk group Emergency

hunt-scheme longest-idle both

!

controller T1 0/0/0

pri-group timeslots 1-24

trunk-group Emergency timeslots 1

Regards.

J Rosa

New Member

trunk-group command under controller T1 in which IOS is availabl

Thanks everybody for the support.

Thas was my problem, the PRI was configured before the Trunk Groups, therefore it won't show up, I need to remove the pri-group, added again and this time it shows the command.

So in order to show up the command, we need to configure the Trunk Group prior the PRI.

Regards

418
Views
0
Helpful
5
Replies
CreatePlease login to create content