Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunk h.323 between CUCM and Nortel Meridian

Hi, anyone has experience about connection of a CallManager ver.6.x or 7.0 with a PBX Nortel Meridian Option 11c via H.323 trunk?

There are issues on Nortel about sw version, license or hardware ?

There are documents relating to this solution?

Thanks, Lorenzo

4 REPLIES
Bronze

Re: Trunk h.323 between CUCM and Nortel Meridian

See if the attached file helps.

MK

New Member

Re: Trunk h.323 between CUCM and Nortel Meridian

Hi,

thanks for your response.

I had already seen this document, but I have not found anything about connection via trunk IP H.323. I can't connect the two system via E1 Q-SIG.

The Nortel Meridian have ITG card (for trunk with remote pbx) and Signalling Server (NTDU27DC Rel.4.5).

Lorenzo

Hall of Fame Super Red

Re: Trunk h.323 between CUCM and Nortel Meridian

Hi Lorenzo,

Perhaps this doc may help (the basic concepts should carry over);

Nortel Communication Server 1000M Release 4.0 using H.323

Trunk to Cisco Unified CallManager Release 4.1(2)

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/445274no.pdf

Hope this helps!

Rob

New Member

Re: Trunk h.323 between CUCM and Nortel Meridian

hi Rob, I'd like to connect and Nortel CS 1000 with h.323 trunk to a cisco 2800 sip gateway.

Nortel--h.323.--router/gateway--sip--AS

Thanks

1176
Views
0
Helpful
4
Replies
CreatePlease login to create content