How possible to perform direct call between two VoiP routers, such as I have one office with 2921 CUCME+VOip users and another one office with CUCME 2921+VOip users, how users perform VOIP call between these networks.
The config I provided would allow for either, the protocol is driven by the dial-peer configuration, if you have "session protocol sipv2" under the dial-peer then it's SIP, if there is no such line then it's H.323.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...