Two fax machines connected to an ATA

[victorgarciaternero]

I have configured the second port of an ATA whith the same config of the first one, but I can't receive anything through this port (the two fax machines work properly in the first port). But I can send a fax through the two ports. Is it possible to use the two ports of the ATA to connect two fax machines?

Thanks.

Best regards.

[Rob Huffman]

Hi Victor,

Just a thought here, but the second port of an ATA only supports g.711;

Have a look at these two good posts that relate to this type of issue;

From Paul @ Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddc9467/3#selected_message

From Jan;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf3e5c/4#selected_message

Hope this helps!

Rob