When dialing main number that routes over analog line to FXO port I recieve a busy signal. I have set up extension 1001 as automated attendant extension number. This number works fine if I dial from an IP phone, but rings busy if I try to dial from outside. I have connection PLAR 1001 on port 0/1/0. Any suggestions would be appreciated.
I will try the connection plar on this voice port. I do have some new information though. Hopefully you can help. If I make an outbound call from the same voice port, it will not connect, but if I disconnect that call and immdiately try again, it will connect. Then if I call my inbound main number it will go through, but only once. I then have to make the outound call again to free up the port. It's like the port is not being freed up when I hang up the call. I should add that when I can successfully dial in withough getting the busy signal, I still do not hear my automated attendant, the call just sits their until I disconnect. I will post the debug xpm signal.
I tried some of these, but to no avail. They all seem to apply to earlier IOS versions. I am on 12.4(20). The call is now being picked up by the AA, but I'm not sure why. If the call is answered by the router or a phone the port clears, but if it doesn't get answered and the calling device terminates, then the port remains siezed. Thanks for the help!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...