Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC 520 CUE session not starting

Good Evening all,

I am trying to initaite a session onto the CUE module of my UC 520.

It just continuously says waiting.

I have tried clearing the session but no luck.

I can ping the service module and everything seems to be setup correctly.

Does anyone have any ideas on this?

3 REPLIES
Hall of Fame Super Gold

UC 520 CUE session not starting

Waiting = Something is wrong with related configuration.

New Member

UC 520 CUE session not starting

Here is what i did to configure it

  1. Create      loopback address

CME(config)#interface loopback 0

CME(config-if)#ip address 10.0.1.1 255.255.255.252

CME(config-if)#no shut

CME(config-if)#exit

  1. Configure CUE module

CME(config)#interface intergrated-service-engine 0/0

CME(config-if)#ip unnumbered loopback 0

CME(config-if)#service-module ip address 10.0.1.2 255.255.255.252

CME(config-if)#service-module ip default-gateway 10.0.1.1

CME(config-if)#no shut

CME(config-if)#exit

  1. Create Route to allow communication to the CUE module

CME(config)#ip route 10.0.1.2 255.255.255.255 integrated-service-engine 0/0

Are there any other steps that im missing?

Or could it be that something is wrong with the module itself?

It says its in steady state and its  CUE 8.6.3

Hall of Fame Super Gold

UC 520 CUE session not starting

I recommend that you configure  unnumbered to a LAN interface and avoid the loopback completely.

164
Views
0
Helpful
3
Replies
CreatePlease login to create content