I have a networking with DSL connection going into ASA 5505 and UC320 connected with it. I have two analog lines going into UC320 and Sip Trunk.
UC320 is configured to route VOICE and DATA.
ASA5505 - is giving 192.168.1.1 - PPOE
UC320 is giving 192.168.10.1 for Data - Vlan 1, and Voice is VLAN100.
- Network is working fine however but couple problems with voice.
Sip Trunk Registration is fine but if I select SIP trunk as primary route to make outgoing calls than phone system do not work. According to sip trunk provider - calls are going to their system but they are disconnecting right away. I also entered an accesslist to allow all trafic from trunk provider. But voice is still not working.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...