Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

UC500 and failover connection

I have a UC500 & ASA5505. Both systems were in place and working when I took over the site. I'm more familiar with ASA, and I've been tweaking that.

I have route tracking setup on the ASA with a T1 (primary 'outside') and DSL (secondary 'backup').

When the T1 goes down, the DSL route is automatically injected as the default route. I'm still very new to CME, so how would I accomplish minimal downtime on the UC500?

The last time we had an outage, the computers were all online fine, but the VoIP system was down.

Where do I begin?

120
Views
0
Helpful
0
Replies
CreatePlease to create content