I have a UC500 set up to allow VPN access, which is working just fine. I have the VPN Remote IP Range configured and this works fine. My problem is, a client connects via VPN, their IP address (from the VPN remote ip range) is being added to DNS and is causing problems when they connect to the network while in the office. How do I configure the UC500 not not update DNS when clients use VPN?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.