Hi there i am installing an UC500 at a customer site. The CCME version of this UC500 is 4.2.3. I implemented the Called Name Display like it is mentioned on the Cisco site. First activate the service DNIS Dir-Lookup and also activated the service DNIS Overlay. Then put the MSN number of the ISDN line in the Directory Entry. But when somebody calls the extension i only see the Caller ID and not the Called ID. Could somebody help me with this ?
Well, you have to check. For our CME's we always setup a VPN or something to access device from remote, because customers always want some change and it's too impractical to get on site for any small need.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...