Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

UC500 implementation

hello folks

i have a question i'm configuring an uc520. i configured an ip to the physical wan interface however the ip address under telephony-service belongs to a different subnet do you guys recommend that kind of implementation or should i assign the same ip address to the cme ?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: UC500 implementation

Generally, you would not assign the WAN address under telephony-service. The telephony-service address is the address to which your phones will register and will usually be either the loopback or the voice VLAN address.

Hope this helps.

Brandon

1 REPLY
VIP Purple

Re: UC500 implementation

Generally, you would not assign the WAN address under telephony-service. The telephony-service address is the address to which your phones will register and will usually be either the loopback or the voice VLAN address.

Hope this helps.

Brandon

122
Views
0
Helpful
1
Replies
CreatePlease to create content