UC500 MWI - doesn't work for newly created range of extensions
MWI does not work newly created extension outside of the default range i.e. 201-252. For e.g. i create a new extension "7514" to match with my isdn 4 digit suffix. I then create a user and associate a VM to it. VM works but MWI doesn't..Any ideas please.
Re: UC500 MWI - doesn't work for newly created range of extensio
The number of dots (....) as shown below should be equal to the extension length being used. In your case this is probably currently set to three which won't work for your new 4-digit DN's. The easiest way to fix this would be to use a consistant DN Length :)
Have a look at this excellent Troubleshooting doc;
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.