UC500 outbound calls

[acomiskey]

I am attempting to use a single analog pots line in an FXO port for outgoing calls. The line is currently working for incoming calls just fine. Is is possible for this to work? If I dial "9" all I get is unknown number and a busy tone. Thanks.

[paolo bevilacqua]

Likely DP need proper configuration.

[jbarcena]

As already noted seems to be a problem with your config. why don't you post the show run and we can go from there

[acomiskey]

Thanks guys. I added "port 0/1/1" and have the following. It is now working outbound.

dial-peer voice 51 pots

corlist outgoing call-domestic

description ** FXO pots dial-peer **

translation-profile outgoing CALLER_ID_TRANSLATION_PROFILE

preference 5

destination-pattern 91[2-9]..[2-9]......

port 0/1/1

prefix 1

no sip-register

I have a lot to learn.