Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC500

this is for p.bevilacqua -

5 REPLIES
Hall of Fame Super Gold

Re: UC500

Give a static address of 192.168.10.1 to FA0.

Under pool phone add corresponding network.

Unrelated, you can consolidate a lot of DP together if you place the FXOs port in trunk group, and reference the latter instead of port under DP.

Hall of Fame Super Gold

Re: UC500

whoops, reading better current config:

- don't change fa0

- configure a vlan100 interface and give it a different network address

- configure that address as ip source under telephony-service

- configure network, default router and option 150 for the above under dhcp pool phone

if you have problems with the PC connected to phone not having connectivity, change mode to trunk under all FA ports.

New Member

Re: UC500

if you give static ip under fa0/0

then you have to connect this interface to the inbuilt switch for the phones to reach default gateway?

Hall of Fame Super Gold

Re: UC500

There is no need to make any connection.

Just configure the dhcp pool for the phones so that default gateway is the VLAN address of the router.

New Member

Re: UC500

thx..

i got it.

i was just replying to your first solution which was to give ip to int fa0.

153
Views
0
Helpful
5
Replies