UC520 and ad-hoc conference with more than 3 parties
I'm struggling trying to get ad-hoc conferencing working on our UC520 with more than 3 parties. I've been told there are enough DSP resources and that this is possible on this unit. I've attached the commands which should make this possible to this post. Here are the parts of modifying my config I think where the problem may lay:
UC520(config-voicecard)#sccp local loopback0
This change requires SCCP to be in shutdown state.
UC520(config)#sccp ccm 10.1.1.1 identifier 1 version 4.1
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...