Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC520 and FXS

Hi to all,

two simple question:

1) can I use one of FXS port builted-in the UC520 to connect a modem of fax server (like Microsoft)?

ATA186 doesn't manage modem (only fax).

How have to connect FXS port to route the incoming call from a BRI to a particular FXS port. (I never use fxs!!!)

2) Is the access-list in UC520 possible to manage only by CLI? I find a easy way (like SDM) to manage the default access-list. SDM is not compatible and Configuration Assistant does not manage ACL.

Can I delete all ACL in uc520?

Thank you very much.

Augusto.

1 REPLY
Hall of Fame Super Gold

Re: UC520 and FXS

Augusto,

1. yes, configure a pots DP with destination-pattern same the called number.

2. you can use the web interface for IP telephony. Yes you can delete all ACL if no special reason to have them.

Hope this helps, please rate post if it does!

118
Views
5
Helpful
1
Replies
CreatePlease to create content