Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

UC520 CUE IP setup

Why is it that the default UC520 setup uses a /30 subnet for the CUE configuration? Can I do without that and simply assign an IP to CUE that is the same as my voice VLAN?

Thanks,

Diego

1 REPLY
Hall of Fame Super Gold

Re: UC520 CUE IP setup

The cue must be accessed via the service-engine interface. If you want to give it an address off router LAN, you can use an host route to it. This technique is described in the configuration manual.

119
Views
3
Helpful
1
Replies
CreatePlease to create content