We have a UC520 running uc500-advipservicesk9-mz.150-1.XA. When we power up a 7925, we can see it registers with thebuild in AP of the UC520. then as it tries to get an IP address or tries to register, the UC520 reboots automatically and a crashfile is created (I hae attached it to this post).
The firmware for the 7925 is on the flash of the UC520 (CP7925G-1.3.3.LOADS)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...