08-13-2009 10:06 AM - edited 03-15-2019 07:21 PM
Hi. I need configure the FXS port, in the Cisco UC520. The Cisco Configuration Assistant show error messages, and I would like configure the analog phone from the CLI .. I can configure the analogic phone connected to FXS from the CLI ??? How I can do it??
thanks
08-13-2009 10:11 AM
If you want dual-line and features, follow the guide for "FXS port in SCCP mode" that is contained in the administration guide. In fact, the UC520 do come pre-configured for that already.
Else, configure a regular pots DP pointing to the port, that is enough.
08-13-2009 10:21 AM
Thanks. p.bevilacqua
I want configure single line in the analog phone. The configuration of the FXS is empty, as following:
voice-port 0/0/0
!
08-13-2009 10:24 AM
Check if the port actually register as ephone. Recommend you configure as SCCP mode so the will be able to transfer calls, a common request.
It's all explained in the guide, you will either read it, or give the job to a professional.
08-13-2009 12:47 PM
I resolve my problem :D
voice-port 0/0/0
station-id name Phone01
station-id number 800
dial-peer voice 800 pots
destination-pattern 800
port 0/0/0
:D
08-13-2009 12:51 PM
Sure, but be prepared to answer "you can't" when user ask "how do I transfer a call ?".
08-13-2009 08:24 PM
you are right, but I dont know to enable SCCP in FXS port :(
(How could I know the MAC address of the FXS)
Thanks
p.bevilacqua
08-14-2009 12:52 AM
In the manual it tells you how, with clear examples. Also, the default configuration file for UC520 has all the commands in there already.
Leave auto-registration on, the port registers and you see the mac with "show ephone".
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide