OK - This is a little bit weird, but I'll do my best to explain the scenario......Here we go.....I have a customer that has a current Nortel PBX, customer has given me 4 analog lines (extensions 100,101,102,103) off of his Nortel. These analog lines are routed to the FXO ports on the 540. Then on the 540 we have the FXS ports tied to some handsfree equipment. So the scenario is this. The customer dials one of the ports ie 100, this in turns triggers the co port on the 540 to go offhook. The 540 then rings one of the FXS ports on the 540. The handsfree equipment answers on this FXS port. The problem is when the person that initiated the call hangs up, all you hear on the other end is reorder tone. It never disconnects.......
Any suggestions as to what I can look for.........
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...