Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC540 Incoming call goes directly to Voimemail Access Extension

Hi everyone,

I'm new with this so please be lenient with me.

I had to change the setup of a Hunt Group and a related Call Blast Group. I disabled it and re-enabled it afterward. But since all incoming call goes directly to Voimemail Access Extension. And I'm unable to fix the issue.

Everytime someone calls they get "Enter your ID followed by #"!

What do I have to do so that all call goes back the the Hunt Group?

Thanks in advance for your help!

4 REPLIES
Green

UC540 Incoming call goes directly to Voimemail Access Extension

Hantz,

Can you provide the config " show run" of the UC500 and point out which pilot and hunt group you are having the issue with.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
New Member

Re: UC540 Incoming call goes directly to Voimemail Access Extens

Sure the "show run" is in attachment

As you can see, it is a bare configuration, so I'm having issue with Hunt Group 1 Pilot # 501 &, Call Blast 1 Pilot # 511.

Feel free to point out any configuration which are not right. But other than that it's working just fine.

I really appreciate the help!

New Member

Re: UC540 Incoming call goes directly to Voimemail Access Extens

Ok I'm kind of ashame to admit it put but the issue was so simple it makes me look dumb.

When I disabled the Hunt Group which was configured for all Incoming Call the system fill it with 399.

So in Dial Plan - Incoming I switched it back to 501 for all 4 FXO.

Green

UC540 Incoming call goes directly to Voimemail Access Extension

Hi Hantz,

Dont feel ashamed because you think you have made a mistake.
At least you have realised that something is wrong and you are
seeking help. You learn that way. You certainly are not the first
person and you will not be the last to cause an issue.

Looking at your config:-

The fxo port are all set to PLAR 399

e.g.

!
voice-port 0/1/0
trunk-group ALL_FXO 64
cptone CA
connection plar opx 399
description Configured by CCA 4 FXO-0/1/0-Custom-HG-OP
caller-id enable
!


Change the PLAR OPX to the pilot number you want.
Like:-

!
!
voice-port 0/1/0
connection plar opx 501
!

etc etc

Hope this is what you are looking for

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
256
Views
0
Helpful
4
Replies
CreatePlease login to create content