01-16-2014 01:13 PM - edited 03-16-2019 09:17 PM
All,
I have a UC540 at a site that if it loses power and goes down hard when it comes back up it has reverted to an older configuration. I don't see anywhere to list a backup of the config, I save the run to start and that's it. It seems not to happen if I issue a reload command, only on a power failure. Anyone seen this or know where I might start looking for the cause?
Thanks. Replies rated.
01-16-2014 01:18 PM
Maybe this can point you in a direction
https://supportforums.cisco.com/thread/2135073
Sent from Cisco Technical Support iPad App
01-16-2014 01:28 PM
Thanks Hermanus! I think that last entry on the post should fix me up quite nicely
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: