Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UC560 and SIP/PRI

Hi, I have a UC560 (UC560-FXO-K9). Can i connect a SIP trunk directly to the WAN port on this unit or do I need a separate connection card. Does the same go for PRI?

If i need a separate card is this the right part number? (VWIC2-1MFT-T1/E1)

 

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions

You can use the WAN port for

You can use the WAN port for SIP connections. 

The card number is correct for a single port PRI. 

Please rate useful posts.
2 REPLIES

You can use the WAN port for

You can use the WAN port for SIP connections. 

The card number is correct for a single port PRI. 

Please rate useful posts.
New Member

 Keep in mind a SIP trunk is

 

Keep in mind a SIP trunk is a virtual trunk. Anything that is an IP Circuit/Transport can be configured as a SIP trunk. Anything from an Ethernet port, to a Fiber Optic SFP, or a T1 configured for Data can be used as an underlying IP transport for a SIP trunk.

71
Views
0
Helpful
2
Replies