So I have firmware on a CD in the drive. On UCM 6.1 what is the directory path I need to use. I have tried everything linux-wise I can think of and it keeps saying its unable to mount the local file system.
Please help, I need to get this 7915 firmware on there for my users.
I upgraded the firmware for the phone and I just got off the phone with an engineer that told me to make sure I specified the load name in Expansion Module Information of the phone. I was going to post back what I found out, but you had it covered already. Thanks!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...