Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCM 6.1 SIP config for Opentext Rightfax 9.4

Hello,

We are deploying a fresh install of Rightfax 9.4 with an SR140 virtual Brooktrout board that speaks to our UCM 6.1 via SIP. I have no idea how to configure the SIP connection on the UCM side. Any ideas?

Also, I have a block of 300 DIDs to use for my Rightfax server. Do I through these on the same Trunk Group as my existing phone DIDs? If so, how do I configure these fax numbers to see my Rightfax server via SIP.

Just a little confused here ;)

1 REPLY

Re: UCM 6.1 SIP config for Opentext Rightfax 9.4

The SIP should be easy to set up. Give it the device pool and SIP settings for a normal gateway.

The only real thing you need to worry about are these things:

-Make sure Rightfax is sending the SIP to an IP address and not a domain name

-The remote IP address at the bottom of the trunk is the source IP of Rightfax

-The Calling Search Space assigned to the trunk has access to the right partitions to call what you want.

The routing of your DIDs is going to be done through a route pattern that points towards your SIP trunk.

-nick

408
Views
0
Helpful
1
Replies