Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UCM BE 6.12 and Mobility

I am looking for the ability to call one extension and have multiple outside extensions ring at the same time as the extension. Is this possible with just Unified Communications Manage Business Edition 6.12. Would you need a mobility server to do something like this? Would functionality like this be built into a version 7 server.

4 REPLIES
Super Bronze

Re: UCM BE 6.12 and Mobility

Hi

This used to be a seperate product (MobilityManager), but since CM6.x it's built into the standard product.

You don't need a seperate server, but each user you enable for the feature uses up an extra DLU (Device License Unit).

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: UCM BE 6.12 and Mobility

Hi,

I'm using CM 6.1 connected via FXO.

How can i configure to allow multiple phones to ring at then same time? Thanks

Green

Re: UCM BE 6.12 and Mobility

check features guide for cucm 6.x

fxo r not supported for mobile connect. you need t1 pri.

New Member

Re: UCM BE 6.12 and Mobility

Gonzalo,

I have a case involving a gateway with T1 CAS and T1 PRI. Some DID's come in on the CAS, and some on the PRI.

Assuming that my calls route out over the PRI, will I have any issues with calls that came in via the CAS?

Thanks,

Jeff

287
Views
0
Helpful
4
Replies