Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UCM Restrict Caller ID for specfic phones to PSTN

Hi All,

Is there a way to restrict certain phones from sending caller ID to same PSTN e1 gateway H323 In CUCM 7/8.

In CUCM there is calling party presentation field on GW it self - though this effects all phones if we select off.

The requirement is to allow certain phones and to restrict others.

So for example a subset of phones do not display a number to called party and the others do.

restrict : Ext 4444- cals 888111111 via PSTN the called party see from Private

alllow:    Ext 4444- cals 888111111 via PSTN the called party sees from 2122224444

Also In nothing is put on the specific phone such as mask  it displays the main number

thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: UCM Restrict Caller ID for specfic phones to PSTN

Not that I`m aware off if you would something from a service parm level but from configuration you can

First ask your Telco to allow CLI to be sent by you

Option 1-Manual

Set up two duplicate Route patterns 9 ( to send CLI) and *9 (to block) and set the Presentation level for reach route pattern- tell userd which one to use for CLI or no CLI

Option 2-automatic

If the user, phone who wish to send CLI`s  are fixed, known then as above but create another Partition called ALLOW CLI. Copy your existing Route pattern and assign the new partition to it. Now copy the CSS you use for PSTN access and rename as ALLOW CLI and replace the  existing Partition you use for PSTN access with the  new one ALLOW CLI . Now assign the new CSS to any user who wishes to have CLI to be sent.

hope it helps

2 REPLIES
Silver

Re: UCM Restrict Caller ID for specfic phones to PSTN

Not that I`m aware off if you would something from a service parm level but from configuration you can

First ask your Telco to allow CLI to be sent by you

Option 1-Manual

Set up two duplicate Route patterns 9 ( to send CLI) and *9 (to block) and set the Presentation level for reach route pattern- tell userd which one to use for CLI or no CLI

Option 2-automatic

If the user, phone who wish to send CLI`s  are fixed, known then as above but create another Partition called ALLOW CLI. Copy your existing Route pattern and assign the new partition to it. Now copy the CSS you use for PSTN access and rename as ALLOW CLI and replace the  existing Partition you use for PSTN access with the  new one ALLOW CLI . Now assign the new CSS to any user who wishes to have CLI to be sent.

hope it helps

New Member

Re: UCM Restrict Caller ID for specfic phones to PSTN

Thank you for the response much appreciated

331
Views
0
Helpful
2
Replies