UCM6.1 - Can Phones auto-configure DPool / Services etc. ?
I am shortly going to be upgrading from 4.0 to 6.1 I am wondering if deployment of new handsets is any easier and whether device mobility could assist with part of this.
In 4.0 I currently have phones auto-register. I then manually configure Device Pool, Location, IP services (extension mobility) and enable extension mobility. Phone is then ready for use (as all my users are extension mobility users).
Is it possible that in UCM6.1 phones that autoregister are assigned to the correct device pool and location (based on DHCP address), rather than the default for the device type ?
Can auto-registered phones have settings such as enabling extension mobility and subscribing to the extension mobility service configured when they auto-register ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.