Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

unable to dial international call from vg202

Hi,

I have fax connected to VG202 and I am not able dial any international call (any number start with 00) from the fax, I tried to connect a normal analog phone to the VG202 but i have the same issue, I keep getting fast busy tone.

I gave the same number which was given to the fax to another IP Phone and the call is going through without any issue.

could you please assist.

Regards,
Mohammad

3 REPLIES
VIP Super Bronze

Re: unable to dial international call from vg202

What protocol is the VG202 using: MGCP, SCCP, H.323, or SIP?

If MGCP or SCCP all of the call routing is performed in UCM. What CSS is assigned to the DN and port?

If  H.323 or SIP, does the dial peer toward UCM get matched? Does UCM get offered the call?

Community Member

Re: unable to dial international call from vg202

Thanks a lot Jonathan for your reply,

It is running SCCP, and the call routing is done on the call manager, I have

assigned international CSS for this line which is working fine for all other

phones, do you have any clue.

Appreciate your cooperation.

Regards,

Mohammad

Community Member

Re: unable to dial international call from vg202

this is strange, when I add the # after the number in the route pattern and

discard it the fax can dial international !!!

regards,

Mohammad

309
Views
0
Helpful
3
Replies
CreatePlease to create content