12-28-2011 08:40 PM - edited 03-16-2019 08:44 AM
Im trying to test adhoc conferencing on a newly installed phone system (UCMBE 8.x).
I'm using the following steps:
Dial participant 1, establish call
press confrn button
Dial particpant 2, establish call
press confrn button
When I press the confrn buttton the second time, both calls are immediately dropped.
How do I go about troubleshooting this?
Solved! Go to Solution.
12-29-2011 07:44 AM
Dial participant 1 click on conf dial participant 2 then click on join not conf again
And I am assuming that you have the right media resources assigned to the calling phone with software or hardware conf brg resource
Hope this help
Sent from Cisco Technical Support iPhone App
12-29-2011 07:44 AM
Dial participant 1 click on conf dial participant 2 then click on join not conf again
And I am assuming that you have the right media resources assigned to the calling phone with software or hardware conf brg resource
Hope this help
Sent from Cisco Technical Support iPhone App
12-29-2011 08:05 AM
The issue was that I didnt add the IOS bridge to the media resource group.
thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: