I am trying to configure an ata 186 and I have already configured it in the CCM admin page with the mac address, phone # ,devie pool and locatio n and all the necessary parameters for the ATA but somehow . I am unable tpo pull an ip address from the CCM. The phones are coming up fine after configuration. I am using H323 and I am even seeing the mac address in the mac address table either. The switch is not recognnizing the devise either.
I was meant to understand that this ATA was a used one and it used to work in anther location previously. Please help.
Re: unable to get ATA to pull ip address in CCM ver 6
What is the speed/duplex on the network port configured for? ATA 186 devices can only communicate at 10/Half, I also believe that it is not capable of auto-negotiation. I have had this problem in the past and hard coding the speed/duplex fixed it for me.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...