Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

unable to get the CLID to work on a FXS port (MGCP controlled gateway)

I am using cucm 8.6, configured a mgcp gateway and configured the fxo and fxs port(s).

CLID presentation to the FXO port -> ip phones works perfectly, but the clid doesnt seem to get presented on the FXS port when debug on the gateway.

Is this a know issue with FXS ports and i should use a ATA-186 to get the CLID Presentation to a Analog phone to work normally ?

On the voice-port i configured the following:

 

voice-port 1/0/0
 cptone NL
 timeouts interdigit 2
 description Main-Phone
 station-id name Main-Phone
 caller-id enable
 caller-id alerting ring 2

 

It doesn't seem to matter if i use pre-ring, of line reversal caller-id alerting method.

any help is appreciated.

 

regards

 

29
Views
0
Helpful
0
Replies