cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
317
Views
0
Helpful
1
Replies

Unable to route calls from FXO

mangesh-bhende
Level 1
Level 1

Hi All,

I have below CME setup and i am able to call from Analog phone connected to FXS port to all PSTN numbers but unable to receive call from PSTN on to the analog phone connected to FXS port. I can see the PSTN call is hitting my FXO port but cannot receive call on to my analog phone. Can any one help me?

IPT.jpg

Regards

Mangesh Bhende

1 Accepted Solution

Accepted Solutions

dksingh
Cisco Employee
Cisco Employee

On the inbound call from telco  to the FXO, does the analog phone on FXS port even ring ?

I'd suggest to change ring number to a lower value (say 2 or default) and then shut/no shut

the port so that we close the loop quicker.

Can u pl. make that change and test?

If it still fails, can u provide deb voip ccapi inout and deb vpm sig along with config?

View solution in original post

1 Reply 1

dksingh
Cisco Employee
Cisco Employee

On the inbound call from telco  to the FXO, does the analog phone on FXS port even ring ?

I'd suggest to change ring number to a lower value (say 2 or default) and then shut/no shut

the port so that we close the loop quicker.

Can u pl. make that change and test?

If it still fails, can u provide deb voip ccapi inout and deb vpm sig along with config?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: