unable to run the fonctionality of CUCM 7 in second node
I have installed 2 CUCM 7.1.3 (Publisher and Subscriber).
When the primary node goes down, the IP phone enregestred with the secondery node correctely but the fonctionality like "Extension Mobility" can't work; this problem because I have configured in the URL in IP phone service configuration the IP adress of the primary node.
I want to know if there's any methode to configure a logical adress that can refer to the both servers; or any other methode to solve this issue.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...