Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to see an IPT phone

We are configuring an IPt network. the switch is a 3750 and the phones (5) are 7942. the strange is that 4 phones are ok while the last phone is not able to get an ip address and the configuration.

the DHCP is in the UCM. The port where is connected the last phone is flapping up-down. In the switch there are some security paramentes (dhcp snooping,arp inspection, verify source....):

ip dhcp snooping vlan 100,102,116-117

no ip dhcp snooping information option

ip dhcp snooping database flash:/DHCP_Snooping_Table_3750

ip dhcp snooping

ip arp inspection vlan 100,116


interface FastEthernet1/0/5

description Cisco ip phone + PC (DHCP)

switchport access vlan 100

switchport mode access

switchport voice vlan 116

switchport port-security maximum 2

switchport port-security

switchport port-security aging time 2

switchport port-security violation restrict

switchport port-security aging type inactivity

srr-queue bandwidth share 1 10 70 20

srr-queue bandwidth shape 3 0 0 0

priority-queue out

mls qos trust device cisco-phone

spanning-tree portfast

ip verify source

ip dhcp snooping limit rate 10

we removed all these security features but nothing happens. we tried to move to phone to another port, change the cable or put anothe phone in this port but the situation is always the same

Hall of Fame Super Silver

Re: Unable to see an IPT phone

When you say situation is always the same do you mean the same phone does not come up on another port or another phone does not come up on this port?

What does the phone log say?

Is the port in the same VLAN?

Do you have sufficient number of IPs in the DHCP scope?

Does "show logging" reveal anything on the switch?



CreatePlease login to create content