Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Unallocated/unassigned number

In below debug isdn q931 is the unallocated/unassigned because the calling party number says “local number”?

In this case the Castelle fax press is dialing my home fax machine at 919043399696

I'm guessing this Castelle fax press sending local number is making the MGCP/PRI unhappy?

Router3#

002082: Nov 7 18:35:12.251 EDT: ISDN Se0/3/0:23 Q931: RX <- SETUP pd = 8 callref = 0x0056

Bearer Capability i = 0x9090A2

Standard = CCITT

Transfer Capability = 3.1kHz Audio

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98388

Exclusive, Channel 8

Calling Party Number i = 0x0080, 'local number'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '919043399696'

Plan:Unknown, Type:Unknown

002083: Nov 7 18:35:12.255 EDT: ISDN Se0/3/0:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x8056

Cause i = 0x8081 - Unallocated/unassigned number

002084: Nov 7 18:35:17.671 EDT: ISDN Se0/2/0:23 Q931: RX <- DISCONNECT pd = 8

1 REPLY
Hall of Fame Super Gold

Re: Unallocated/unassigned number

Hi,

Is this interface connected directly to PSTN, or something else? If so, the problem is the leading 9 in called number, not supposed to be there.

Admittedly,

Calling Party Number i = 0x0080, 'local number'

is very strange, but perhaps that is some default value that has not been changed.

247
Views
0
Helpful
1
Replies
CreatePlease to create content