I need to configure AAR in one of the UC labs. I have a question here regarding the Dial prefix. There are two dial prefixes.One from this group another to this group.
I am not sure whats the use of Prefix(to this group).For example I have two sites one Central and one remote.They are kept in different location ie.,Location1(cnetral) and Location2(remote) and in two AAR groups AAR1 and AAR2. When the bandwith between these two locations set to zero,the call should be routed to PSTN. So the prefixes are attached from the originating AAR Group and sent to the Respective GW.
In this case whats the use of Prefix(to this group)?. Isnt Prefix from this group is sufficient?.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.