I have CCM 7 and Unity & IP telephony infra. I have configured 1 DID number for VM access for Users from PSTN. I created a CTI route with DID number, forwarded to VM. In the call routing, Forwarded calls i made a Rule from Forwarding Station (DID Number) send call to Sign-IN. when i dial from an outside phone to this DID number it prompts me for USER ID as soon as i enter one it plays me the Opening greeting. when i dial the Same Number from any IP Phone within the organisation it ask me the USER ID and the PASSWORD and properly routes it to the subscriber. I check using port status monitor and it takes the Extension number and then it goes to Opening greeting. Any idea on whats happening ???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.