Unity Connection 8.6 Not Showing Product Deployment Selection
I am attempting to install a new Unity Connection cluster and when I boot to the DVD supplied I am not being prompted to select from Unity/CUCM or CUCM Business edition, it boots straight into CUCM without giving me any options in the product deployment selection screen.
The message "The Cisco Unified Communications Manager product swuite will be installed"
Has anyone experienced this before and has a solution?
My experience has always been with Unity running on a Windows OS.
I found this post and was very useful to me, so I will add that if you are experiencing this problem while attempting to use an .ISO with VMware, you must assign at least 4GB RAM for Unity Connection to be available. Check the supported platforms section for the documentation guide. For example:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.