Client is using Unity connection 8.6 and exchange 2010. They have unified messageing single inbox configured. One user is not getting their VM on in Outlook. No changes have been made, but they ad rebooted their exchange server over the weekend.
When doing the test from the user’s Unified Messaging page, we get the following error,
Failed accessing firstname.lastname@example.org on primary.cisco.pvt (attached is image of error message)
I have compared his configuration to a working one and everything looks good. I did notice the same issue on Netpro and it says to reset the Unity Service account on the Exchange box. Not sure if this would apply because only one user is not getting VM through email. Wondering if there are any services on Unity connection or Exchange thar I could reset.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...