Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unity Connection 9.1 for HA

Hi, existing I only running 1 unit Unity Connection and yesteday i had add in the subscriber and have configure neccesary parameter for HA. During I test down the publisher and can saw subscriber had take over the role as primary, but I fail to reach voice mail. Then I check CUCM and found the voice mail registration are unregister. Then I go to Unity connection serviceability to check the Unity port and found the port for subscriber is 0. Here is my question:-

 - Is it normal which have 0 port?

- If this is not normal, how can I make voice port on subscriber same to publisher is 24 port?

- Is it HA need license?

- Is it I need to recreate the voice mail port at CUCM?

 

Please advice.

Thank you.

John

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Port capacity depends on the

  1. Port capacity depends on the hardware. Assuming VMware since this is a new deployment which means port capacity is dependent upon the OVA you used and whether you have enabled G.722/iLBC or not.
  2. You need to install a license on the subscriber server. For this you need to place an order even though the HA server is free, you still need a PAK.
  3. Yes, see answer two.
  4. The subscriber will have it's own port group within CUC and additional voicemail ports in CUCM.
    http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/9x/integration/guide/cucm_sccp/cucintcucmskinny/cucintcucmskinny070.html#wp1097184
Please remember to rate helpful responses and identify helpful or
2 REPLIES
VIP Super Bronze

Port capacity depends on the

  1. Port capacity depends on the hardware. Assuming VMware since this is a new deployment which means port capacity is dependent upon the OVA you used and whether you have enabled G.722/iLBC or not.
  2. You need to install a license on the subscriber server. For this you need to place an order even though the HA server is free, you still need a PAK.
  3. Yes, see answer two.
  4. The subscriber will have it's own port group within CUC and additional voicemail ports in CUCM.
    http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/9x/integration/guide/cucm_sccp/cucintcucmskinny/cucintcucmskinny070.html#wp1097184
Please remember to rate helpful responses and identify helpful or
New Member

Hi Jonathan,Thanks for your

Hi Jonathan,

Thanks for your response and answer.

62
Views
0
Helpful
2
Replies