Are you looking to use Single Inbox feature? If so then you need to integrate UCON with Exchange, here is a link to config guide, but there are also many threads on this forum discussing the config if you have further questions:
Single Inbox allows you to synchronize messages in UCON with Exchange so that you get full Unified Communications experience. Messages are basically copied from UCON message store to Exchange mailstore and full synched so that if you listed to it in Outlook client for example MWI is turn off, if you delete it from Exchange it is deleted in UCON. This is basicallt the next hop after SMTP Relay that was offered intitially with UCON to be able to deliver voice messages into single unifed mailbox.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...