Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity Express 3.1 Cannot Zero Out to Auto Attendant

I have a client that is using UE 3.1. The zero out number is configured as the Auto Attendant in both the Voice Mail > CallHandling > Voicemail operator number and in the individual voice mail boxes. When a caller hits zero the caller get the message that it is transferring to an extension but the call is disconnected.

If I configure the zero out number for a regular extension it transfers.

All help is appreciated.

2 REPLIES
Cisco Employee

Re: Unity Express 3.1 Cannot Zero Out to Auto Attendant

Since you have it configured on all the correct places.

I would insure that the AA number can be dialed and reached internally.

If not verify CME dial peers and CUE triggers.

If a custom script is being used I would try the Cisco default and test.

Debug ccsip messages for one bad call will shed some light on who is sending the bye CME or CUE.

If it is a customer script I would take a look at the Unity Express Custom Scripts Quick Start Guide here for detailed examples of custom call flow

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps5520/products_tech_note09186a008041d950.shtml

New Member

Re: Unity Express 3.1 Cannot Zero Out to Auto Attendant

Thanks for the advice. I was able to fix it by allowing sip to sip calls.

CME(config)#voice service voip

CME(conf-voi-serv)#allow-connections sip to sip

226
Views
5
Helpful
2
Replies
CreatePlease login to create content