Unity Express 7.0.2 completely shuffled after language installation.
I have a Unity Express 7.0.2 with ES41 special patch that migrated from exchange 2007 to 2010. Apparently there are now several exchange servers. The client needed to add a new language so I had to install almost everything again (the unity and re-install the patch). Right now when I click on the messages key on the phone (CUCM phone) have a message that says "The mail server is unavailable". Also I can put messages in VM but they the message led not always work. In some cases I can hear the messages on the phones but can not erase them. Everything indicates that it is permissions problem but i do not know where to start troubleshooting.
At this stage i run the MSCW but not finish the setup because it need to run some scripts in exhange servers. I also can not run the permission wizzard with the accounts of the unity (Unityadmin, unityinstall, unitymsgstoresvc or unitydirsvc, only through an administrator account that customer have.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...