Unity Express 7.0 with CallManager 7.0 CTI Route Point
Is there a CUE CLI command to get reset the CTI integration? During CUE Initialization setup I typed the wrong number for the CTI Route Point, I then corrected in the CUE GUI but in CCM Admin > CTI Route Point > the number showed un-registered.
The only fix was reload in CUE.
Is there not a CUE CLI command to reset the service, seems any JTAPI/CTI issues the first answer is always reload.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...