Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

unity express in SRST

Hello all,

I am having CUE Express AIM2-CUE, installed into 2811 router at one of branch.

Currently CUE is having CCM License file & it is integrated with CCM 7.x at HQ & working perfect.

If my branch router switch into SRST mode, my CUE stops working & it gives fast busy tone if i call from same branch internally or from PSTN. I have created following DP for CUE but still its giving fast busy tone.

dial-peer voice 8088 voip

destination-pattern 8088

session protocol sipv2

session target ipv4:10.0.24.250 (CUE IP)

dtmf-relay sip-notify

codec g711ulaw

no vad

My CUE config is following & my branch is having MGCP gateway i am having CUE 7.X.

ccn trigger jtapi phonenumber 8088

application "voicemail"

enabled

maxsessions 6

end trigger

ccn subsystem jtapi

ctiport 4221 4222 4223

ccm-manager address 10.0.24.20 10.0.24.21

ccm-manager credentials hidden "kqp8kECeSyDrgZAziRUcjPcs5XnGilj/Sd8ZZNgd+Y9J3xlk2B35j0nfGWTYHfmPSd8ZZNgd+Y9J3xlk2B35j0nfGWTYHfmPSd8ZZNgd+Y9J3xlk2B35j0nfGWTYHfmP"

end subsystem

can any body suggest what is the problem ?

Regards,

Ahmed

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Blue

unity express in SRST

Hi Ahmed,

Since you are using CUCM license you also need to use SIP Subsystem and SIP trigger to make it work in SRST.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_configuration_example09186a0080289ef0.shtml

Above link shows the desired configuration.

Regards

Ronak Patel

Please rate helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
2 REPLIES
Blue

unity express in SRST

Hi Ahmed,

Since you are using CUCM license you also need to use SIP Subsystem and SIP trigger to make it work in SRST.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_configuration_example09186a0080289ef0.shtml

Above link shows the desired configuration.

Regards

Ronak Patel

Please rate helpful posts by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

unity express in SRST

Thanks Ronak,

It worked after SIP subsystem & SIP trigger

Regards,

Ahmed

452
Views
0
Helpful
2
Replies
CreatePlease to create content