Ran into an NTP problem with Unity Express 7.0(3). In the GUI, the NTP server was missing and the timezone was wrong. I fixed these items, saved the config and reloaded the CUE module. When it came back up, the NTP server was missing again and the timezone had defaulted back to PST. Thought I would change these using the CLI, but the NTP commands are missing from the CLI. No "ntp server". No "show clock". Anyone else run into this?
When you add it via CLI the system immediately checks whether it is a NTP server or not its not done when you do it via the GUI. Hence when you reload if the NTP fails it wont work figure in the place of NTP server. For cisco Unity express you can do a workaround by pointing NTP to the IP address of router on which it sits. The router in turn should point to the NTP server.
1. If I input the NTP server (loopback interface of the router) using the GUI, I'm able to add the server, change the timezone and save the changes. At this point a reload is required for the change to take effect. After reloading the CUE module, the NTP server is blank and the timezone has defaulted back to PST.
2. In the CLI, the NTP commands are missing. If I type ? at the config prompt, ntp is not listed as a valid command. If I type show ?, show clock is not listed as a valid command
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...