There is only one license that is provided for failover systems, and it goes onto the Primary Cisco Unity server. If you open the license file with Notepad, you should see the field LicSecondaryServerIsLicensed is set to Licensed. This helps ensure that you are correctly licensed. Refer to the Installation Guide for your specific release, for instructions on how to install failover. After installation, Configuring Cisco Unity Failover provides additional detail.
As a confirmation, pull up the licensing applet on the Secondary server. It should display the licensing information that is present on the Primary server
so you are right for not ordering 32 ports for the new unity
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...